Trip Info
Press and release the UP or DOWN button until “Trip Info” is highlighted in the EVIC and press the SELECT button. Press and release the UP/DOWN buttons to highlight one of the following functions if you want to reset it:
Trip A
Shows the total distance traveled for Trip A since the last reset.
Trip B
Shows the total distance traveled for Trip B since the last reset.
Elapsed Time
Shows the total elapsed time of travel since the last reset when the ignition switch is in the ACC position. Elapsed time will increment when the ignition switch is in the ON or START position.
To Reset A Trip Function
Reset will only occur while a resettable function is selected (highlighted). Press and hold the SELECT button to clear the resettable function being displayed.
See also:
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink ...
Instrument Cluster Descriptions
1. Temperature Gauge
The temperature gauge shows engine coolant temperature.
Any reading below the red mark of the gauge shows
that the engine cooling system is operating properly. The
gauge poi ...
Special Care
• If you drive on salted or dusty roads or if you drive
near the ocean, hose off the undercarriage at least once
a month.
• It is important that the drain holes in the lower edges
of the do ...
