Front Side Marker Lamp


 

1. Raise the hood to access the rear of the headlamp housing.

NOTE:
Access is somewhat limited. You may have to remove the inner fender well or remove the headlamp housing for bulb replacement.

2. Twist the socket and remove from the headlamp housing, then pull the bulb out.

3. Push the new bulb into the socket and reinstall the socket by twisting until locked into the headlamp housing.

    See also:

    Designed for Passionate Drivers Who Value Substance and Individuality
    Redesigned from the ground up, the all-new 2011 Chrysler 300 is the freshest entry in the U.S. standard full-size vehicle segment. While the standard full-size segment share has consistently held ...

    Trunk Safety Warning
    WARNING! Do not allow children to have access to the trunk, either by climbing into the trunk from outside, or through the inside of the vehicle. Always close the trunk lid when your vehicle is ...

    Windshield Wipers And Washers
    The wipers and washers are operated by a switch within the multifunction lever. Rotate the end of the multifunction lever to select the desired wiper speed. NOTE: Always remove any buildup of sn ...