To Arm The System


 

Follow these steps to arm the Vehicle Security Alarm:

1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information).

• For vehicles equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF.

• For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF and the key is physically removed from the ignition.

2. Perform one of the following methods to lock the vehicle:

• Press LOCK on the interior power door lock switch with the driver and/or passenger door open.

• Press the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to Keyless Enter-N-Go in Things To Know Before Starting Your Vehicle for further information).

• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.

3. If any doors are open, close them.

    See also:

    Washing
    • Wash your vehicle regularly. Always wash your vehicle in the shade using MOPAR Car Wash or a mild car wash soap, and rinse the panels completely with clear water. • If insects, tar, or ot ...

    To Disarm The System
    The Vehicle Security Alarm can be disarmed using any of the following methods: • Press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter. • Grasp the Passive Entry Unlock Door ...

    Reception Quality
    Satellite reception may be interrupted due to one of the following reasons: • The vehicle is parked in an underground parking structure or under a physical obstacle. • Dense tree coverage ma ...