Fog Lamp


 

NOTE:
Access to the fog lamp bulb is from the rear of the fascia. On the left rear side of the fascia, remove the push pin and lower the hinged access door on the air dam.

1. From behind the bumper fascia, or the access panel on the air dam, twist the bulb counterclockwise, and remove bulb.

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol.

2. Disconnect wire harness from the bulb.

3. Reconnect the wiring harness to the new bulb and reinstall the bulb by twisting clockwise.

    See also:

    Normal Starting
    NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. For vehicles not equipped with Tip Start (Four-Speed Transmission), turn ...

    Shallow Standing Water
    Although your vehicle is capable of driving through shallow standing water, consider the following Caution and Warning before doing so. CAUTION! • Always check the depth of the standing water ...

    Engine Air Cleaner Filter
    Refer to the “Maintenance Schedule” for the proper maintenance intervals. WARNING! The air induction system (air cleaner, hoses, etc.) can provide a measure of protection in the case of engi ...