To Open And Close The Hood

To open the hood, two latches must be released.

1. Pull the hood release lever located under the left side of the instrument panel.

Hood Release Lever
Hood Release Lever

2. Then lift the secondary latch located under the front edge of the hood, near the center and raise the hood.

Hood Safety Catch
Hood Safety Catch

Use the hood prop rod to secure the hood in the open position. Place the upper end of the prop rod in the hole on the left underside of the hood.

Hood Prop Rod Hole Location
Hood Prop Rod Hole Location

NOTE:
Before closing the hood, make sure to stow the prop rod in its proper location.

CAUTION!
To prevent possible damage, do not slam the hood to close it. Use a firm downward push at the center of the hood to ensure that both latches engage.

WARNING!
Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched, it could open when the vehicle is in motion and block your vision.

Failure to follow this warning could result in serious injury or death.

    See also:

    Road Tire Installation
    1. Mount the road tire on the axle. 2. Install the remaining lug nuts with the cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts. WARNING! To avoid the risk of forcing t ...

    Automatic Headlights — If Equipped
    Turning the end of the multifunction lever to the third detent (AUTO), will activate the automatic headlight system. Headlight Switch With the engine running and the multifunction lever in t ...

    Front Map/Reading Lights
    The front map/reading lights are mounted in the overhead console. Front Map/Reading Lights Each light can be turned on by pressing a switch on either side of the console. These buttons are bac ...