Activating Adaptive Cruise Control (ACC)

You can only activate ACC if the vehicle speed is above 20 mph (32 km/h).

When the system is turned on and in the READY state, the Electronic Vehicle Information Center (EVIC) displays “Adaptive Cruise Ready.” When the system is OFF, the EVIC displays “Adaptive Cruise Control Off.”

NOTE:
You cannot enable ACC under the following conditions:
• When you apply the brakes.
• When the parking brake is set.
• When the automatic transmission is in PARK, REVERSE or NEUTRAL.
• When pushing the RES + button without a previously set speed in memory.

    See also:

    Blind Spot Monitoring — If Equipped
    The Blind Spot Monitoring (BSM) system uses two radarbased sensors, located inside the rear bumper fascia, to detect highway licensable vehicles (automobiles, trucks, motorcycles, etc.) that ent ...

    Adding Washer Fluid
    The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level at regular intervals. Fill the reservoir with windshield washer solvent ...

    Starting Voice Recognition (VR) Session in Radio/Player Modes
    In this mode, you can say the following commands: NOTE: The commands can be said on any screen when a call is not active after pushing the Uconnect™ Voice Command button. ...