Vehicles Not Equipped With Keyless Enter-N-Go


 

1. Turn the ignition switch to the ON/RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.

3. Turn the ignition switch to the OFF/LOCK position.

NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps.

    See also:

    Active Head Restraints — Front Seats
    Active Head Restraints are passive, deployable components, and vehicles with this equipment can not be readily identified by any markings, only through visual inspection of the head restraint. T ...

    Tire PSI
    Press and release the UP or DOWN button until “Tire PSI:” displays highlighted in the EVIC. Press the SELECT button to view a graphic of the vehicle with a tire pressure value at each corner ...

    Rear Window Defroster
    The rear window defroster button is located on the climate control (Mode) knob. Press this button to turn on the rear window defroster and the heated outside mirrors (if equipped). An indicato ...