Connecting The iPod Or External USB Device


 

Use the connection cable to connect an iPod or external USB device to the vehicle’s USB connector port which is located in the center of the instrument panel below the climate controls.

USB Connector Port
USB Connector Port

Once the audio device is connected and synchronized to the vehicle’s iPod /USB/MP3 control system (iPod or external USB device may take a few minutes to connect), the audio device starts charging and is ready for use by pressing radio switches, as described below.

NOTE:
If the audio device battery is completely discharged, it may not communicate with the iPod /USB/ MP3 control system until a minimum charge is attained.

Leaving the audio device connected to the iPod /USB/ MP3 control system may charge it to the required level.

    See also:

    Engine Block Heater — If Equipped
    The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...

    To Vary The Speed Setting
    When the Electronic Speed Control is set, you can increase speed by pushing the RES (+) button. If the button is continually pressed, the set speed will continue to increase until the button is ...

    Soft-Keys
    Soft-keys are accessible on the Uconnect Touch™ system screen. Uconnect Touch™ System 8.4 Automatic Temperature Controls — Soft-keys Button Descriptions (Applies To Both Hard-keys And So ...