Using The Remote Control


 

1. Press the MODE button on the Remote Control.

2. While looking at Screen 1 or 2, highlight VES DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER on the Remote Control.

Select VES DISC Mode On The VES Screen
Select VES DISC Mode On The VES Screen

NOTE:
• Channel/Screen 1 select mode information is shown on the left side of the screen.
• Channel/Screen 2 select mode information is shown on the right side of the screen.
• The VES™ will retain the last setting when turned off.

    See also:

    Barge In — Overriding Prompts
    The “Voice Command” button can be used when you wish to skip part of a prompt and issue your voice command immediately. For example, if a prompt is asking “Would you like to pair a phone, ...

    Checking Oil Level
    To assure proper engine lubrication, the engine oil must be maintained at the correct level. Check the oil level at regular intervals, such as every fuel stop. The best time to check the engine ...

    Exhaust Gas
    WARNING! Exhaust gases can injure or kill. They contain carbon monoxide (CO), which is colorless and odorless. Breathing it can make you unconscious and can eventually poison you. To avoid breat ...