Before You Begin Programming HomeLink

Be sure that your vehicle is parked outside of the garage before you begin programming.

For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.

Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:
• Erasing all channels should only be performed when programming HomeLink for the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the Internet at www.HomeLink.com for information or assistance.

    See also:

    MUSIC TYPE Button
    Pressing this button once will turn on the Music Type mode for five seconds. Pressing the MUSIC TYPE button or turning the TUNE/SCROLL control knob within five seconds will allow the program for ...

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood Aja ...

    Reformulated Gasoline
    Many areas of the country require the use of cleaner burning gasoline referred to as “Reformulated Gasoline.” Reformulated gasoline contains oxygenates and are specifically blended to reduce ...