Vehicles Not Equipped With Keyless Enter-N-Go


 

1. Turn the ignition switch to the ON/RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.

3. Turn the ignition switch to the OFF/LOCK position.

NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps.

    See also:

    Voice Command Tree
    Refer to “Voice Tree” in this section. ...

    Replacement Keys
    NOTE: Only keys that have been programmed to the vehicle electronics can be used to start the vehicle. Once a Sentry Key has been programmed to a vehicle, it cannot be programmed to any other v ...

    Enhanced Accident Response System
    In the event of an impact causing air bag deployment, if the communication network remains intact, and the power remains intact, depending on the nature of the event the ORC will determine wheth ...