Clearing A Flooded Engine (Using ENGINE START/STOP Button)

Chrysler 300 / Chrysler 300 Owners Manual / Starting And Operating / Starting Procedures / If Engine Fails To Start / Clearing A Flooded Engine (Using ENGINE START/STOP Button)

 

If the engine fails to start after you have followed the “Normal Starting” or “Extreme Cold Weather procedures, it may be flooded. To clear any excess fuel, press and hold the brake pedal, push the accelerator pedal all the way to the floor and hold it, then press and release the ENGINE START/STOP button once. The starter motor will engage automatically, run for 10 seconds, and then disengage. Once this occurs, release the accelerator pedal and the brake pedal, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    See also:

    Place/Retrieve A Call From Hold
    To put a call on hold, press the button until you hear a single beep. This indicates that the call is on hold. To bring the call back from hold, press and hold the button until you hear a s ...

    Redial
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...

    Automatic Transmission
    CAUTION! Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of REV ...