Hazard Warning Flashers

The Hazard Warning flasher switch is located on the instrument panel, below the radio.

Press the switch to turn on the Hazard Warning

Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.

NOTE:
With extended use the Hazard Warning flashers may wear down your battery.

    See also:

    Electronic Vehicle Information Center (EVIC) Displays
    When the appropriate conditions exist, the EVIC displays the following messages: • Turn Signal On (with a continuous warning chime after one mile traveled) • Left Front Turn Signal Lamp Out ...

    Engine Oil Viscosity (SAE Grade) – 3.6L Engine
    SAE 5W-30 engine oil is recommended for all operating temperatures. The engine oil filler cap also shows the recommended engine oil viscosity for your engine. For information on engine oil fill ...

    Acceleration
    Rapid acceleration on snow covered, wet, or other slippery surfaces may cause the driving wheels to pull erratically to the right or left. This phenomenon occurs when there is a difference in th ...