Installing Child Restraint Tether Strap
1. Rotate the cover over the anchor directly behind the seat where you are placing the child restraint.

Installing Child Restraint Tether Strap
1 — Cover
3 — Attaching Strap
A — Tether Strap Hook
B — Tether Anchor
2. Route the tether strap to provide the most direct path for the strap between the anchor and the child seat. If your vehicle is equipped with adjustable rear head restraints, raise the head restraint, and where possible, route the tether strap under the head restraint and between the two posts. If not possible, lower the head restraint and pass the tether strap around the outboard side of the head restraint.
3. Attach the tether strap hook (A) of the child restraint to the anchor (B) and remove slack in the tether strap according to the child restraint manufacturer’s instructions.
WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchor positions directly behind
the child seat to secure a child restraint top tether
strap.
See also:
Sunroof Fully Closed
Press the switch forward and release to ensure that the
sunroof is fully closed. ...
Precautions While Driving With ACC
In certain driving situations, ACC may have detection
issues. In these cases, ACC may brake late or unexpectedly.
The driver needs to stay alert and may need to
intervene. ...
Totally Integrated Power Module
The Totally Integrated Power Module is located in the
engine compartment near the battery. Refer to the applicable
“Engine Compartment” illustration in this section.
This center contains cart ...
