Using The Remote Control


 

1. Press the MODE button on the Remote Control and either the Mode Select Screen will display or a small banner will appear at the bottom of the screen.

2. To listen to an audio source on Channel 1 or 2, either press Up/Down/Left/Right on the Remote Control to highlight the desired audio source or press the MODE button repeatedly until the desired audio source appears on the screen.

Select FM Mode On The VES screen
Select FM Mode On The VES screen

    See also:

    Programming A Rolling Code
    For programming garage door openers that were manufactured after 1995. These garage door openers can be identified by the “LEARN” or “TRAIN” button located where the hanging antenna is a ...

    Using HomeLink
    To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home ...

    List Paired Mobile Phone Names
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Setup Phone Pairing”. • When prompted, say “List Phones”. • The Uconnect™ Phone will pl ...