Using The Remote Control
1. Press the MODE button on the Remote Control.
2. While looking at Screen 1 or 2, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER.
Select DISC Mode On The VES Screen
NOTE:
• Channel/Screen 1 select mode information is shown
on the left side of the screen.
• Channel/Screen 2 select mode information is shown
on the right side of the screen.
• The VES™ will retain the last setting when turned off.
See also:
Blower Control
Rotate this control to regulate the
amount of air forced through the ventilation
system in any mode. The
blower speed increases as you move
the control to the right from the “O”
(OFF) ...
SAFETY
The 2011 300C has been named a Top Safety Pick by the Insurance Institute for
Highway Safety. For a car to earn this safety nod, it must receive the highest
score of Good in frontal-offset, side-i ...
Weight-Carrying Hitch
A weight-carrying hitch supports the trailer tongue
weight, just as if it were luggage located at a hitch ball or
some other connecting point of the truck. These kinds of
hitches are the most po ...