Auto Unlock On Exit Programming
The Automatic Unlock Doors On Exit feature can be enabled or disabled as follows:
• For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer-Programmable Features)” in “Understanding Your Instrument Panel” for further information.
• For vehicles not equipped with the EVIC, perform the following procedure:
1. Close all doors and place the key in the ignition.
2. Cycle the ignition switch between LOCK and ON/ RUN and then back to LOCK four times, ending up in the LOCK position.
3. Press the power door unlock switch to unlock the doors.
4. A single chime will indicate the completion of the programming.
5. Repeat these steps if you want to return this feature to its previous setting.
NOTE:
Use the Automatic Unlock Doors On Exit feature
in accordance with local laws.
See also:
Steering Wheel Audio Controls — If Equipped
Remote Sound System Controls (Back View Of Steering Wheel)
The remote sound system controls are located on the rear
surface of the steering wheel, at the three and nine
o’clock positions.
Th ...
Starting Procedures
Before starting your vehicle, adjust your seat, adjust the
inside and outside mirrors, fasten your seat belt, and if
present, instruct all other occupants to buckle their seat
belts.
WARNING!
...
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off. ...