To Arm The System
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information).
• For vehicles equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF .
• For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF and the key is physically removed from the ignition.
2. Perform one of the following methods to lock the vehicle:
• Press LOCK on the interior power door lock switch with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to Keyless Enter-N-Go in Things To Know Before Starting Your Vehicle for further information).
• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If any doors are open, close them.
See also:
Add Names To Your Uconnect™ Phonebook
NOTE:
Adding names to the Uconnect™ Phonebook is
recommended when the vehicle is not in motion.
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
...
Weight-Carrying Hitch
A weight-carrying hitch supports the trailer tongue
weight, just as if it were luggage located at a hitch ball or
some other connecting point of the truck. These kinds of
hitches are the most po ...
Special Care
• If you drive on salted or dusty roads or if you drive
near the ocean, hose off the undercarriage at least once
a month.
• It is important that the drain holes in the lower edges
of the do ...