Clearing A Flooded Engine (Using ENGINE START/STOP Button)

Chrysler 300 / Chrysler 300 Owners Manual / Starting And Operating / Starting Procedures / If Engine Fails To Start / Clearing A Flooded Engine (Using ENGINE START/STOP Button)

 

If the engine fails to start after you have followed the “Normal Starting” or “Extreme Cold Weather procedures, it may be flooded. To clear any excess fuel, press and hold the brake pedal, push the accelerator pedal all the way to the floor and hold it, then press and release the ENGINE START/STOP button once. The starter motor will engage automatically, run for 10 seconds, and then disengage. Once this occurs, release the accelerator pedal and the brake pedal, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    See also:

    Coolant Level
    The coolant bottle provides a quick visual method for determining that the coolant level is adequate. With the engine cold, the level of the engine coolant (antifreeze) in the coolant recovery b ...

    To Vary The Speed Setting
    While ACC is set, you can increase the set speed by pressing and holding the RES + button. If the button is continually pressed, the set speed will continue to increase in 5 mph (8 km/h) increme ...

    Reclining Seats
    The recliner control is located on the side of the seat. To recline, lean forward slightly before lifting the lever, then lean back to the desired position and release the lever. Lean forward and ...