Headlamp


 

1. Raise and prop open the hood. Locate the connector behind the headlamp.

NOTE:
It may be necessary to remove the air cleaner filter housing and position the totally integrated power module aside prior to replacing the low beam headlamp on the driver’s side of the vehicle.

2. Reach into engine compartment and from behind the lamp assembly and grasp the connector.

3. Rotate bulb and connector one-quarter turn and pull

3. Rotate bulb and connector one-quarter turn and pull outward from assembly.

CAUTION!

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life.

4. Pull the bulb out of the socket and replace the bulb.

5. If the bulb comes in contact with any oily surface,

5. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

6. Reinsert the bulb and socket assembly and rotate clockwise one-quarter turn to secure.

    See also:

    Pair (Link) Uconnect™ Phone To A Mobile Phone
    To begin using your Uconnect™ Phone, you must pair your compatible Bluetooth enabled mobile phone. To complete the pairing process, you will need to reference your mobile phone Owner’s Manual ...

    Activating Adaptive Cruise Control (ACC)
    You can only activate ACC if the vehicle speed is above 20 mph (32 km/h). When the system is turned on and in the READY state, the Electronic Vehicle Information Center (EVIC) displays “Adapt ...

    Manual Door Locks
    To lock each door, push the door lock knob on each door trim panel downward. To unlock each door, pull the inside door handle. Manual Lock Knob WARNING! • For personal security and safety i ...