General Information

• You can start out, from a stop, in any gear except sixth.

The system will ignore attempts to upshift at too low of a vehicle speed.

• If a ratio other than first gear is selected, and the vehicle is brought to a stop, the transmission control logic will automatically select the first gear ratio.

• Starting out in second gear is helpful in snowy or icy conditions. To select second gear after the vehicle is brought to a stop, tap the shift lever to the right (+) once.

• Avoid using speed control when AutoStick is engaged.

• The transmission will automatically shift up when maximum engine speed is reached while AutoStick is engaged.

• Transmission shifting will be more noticeable when AutoStick is engaged.

• If a downshift would cause the engine to overspeed, that shift will not occur until it is safe for the engine.

• If the system detects powertrain overheating, the transmission will revert to the automatic shift mode and remain in that mode until the powertrain cools off.

    See also:

    Loose Fuel Filler Cap Message
    If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a “gASCAP” message will display in the odometer or a “CHECK GASCAP” messa ...

    How To Disengage The Automatic Locking Mode
    Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode. WARNING! • ...

    Automatic Compass Calibration
    This compass is self-calibrating, which eliminates the need to manually reset the compass. When the vehicle is new, the compass may appear erratic and the EVIC will display CAL until the compass ...