Towing Requirements – Trailer Lights And Wiring


 

Whenever you pull a trailer, regardless of the trailer size, stop lights and turn signals on the trailer are required for motoring safety.

The Trailer Tow Package may include a four-pin or a seven-pin wiring harness. Use a factory approved trailer harness and connector.

NOTE:
Do not cut or splice wiring into the vehicles wiring harness.

The electrical connections are all complete to the vehicle but you must mate the harness to a trailer connector.

Refer to the following four-pin connector and seven-pin connector illustrations.

Four-Pin Connector
Four-Pin Connector

1 — Female Pins
4 — Park
2 — Male Pin
5 — Left Stop/Turn
3 — Ground
6 — Right Stop/Turn

Seven-Pin Connector
Seven-Pin Connector

1 — Battery
2 — Backup Lamps
3 — Right Stop/Turn
4 — Electric Brakes
5 — Ground
6 — Left Stop/Turn
7 — Running Lamps

    See also:

    Maintaining Your Air Bag System
    WARNING! • Modifications to any part of the air bag system could cause it to fail when you need it. You could be injured if the air bag system is not there to protect you. Do not modify the c ...

    Adaptive Cruise Control (ACC) Operation
    The speed control buttons (located on the right side of the steering wheel) operates the ACC system. 1 — DISTANCE SETTING 2 — RES + 3 — SET - 4 — CANCEL 5 — ON/OFF 6 — MODE NOTE ...

    Deploying The Crossbars
    To deploy the crossbars, completely loosen the thumb screws at both ends of the crossbar and lift the crossbar from its stowed position in the side rail. Repeat with crossbar on the opposite sid ...