Using The ENGINE START/STOP Button


 

NOTE:
Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.

To start the engine, the transmission must be in PARK or NEUTRAL. Press and hold the brake pedal while pressing the ENGINE START/STOP button once. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will disengage automatically after 10 seconds. If you wish to stop the cranking of the engine prior to the engine starting, press the button again.

    See also:

    Language Selection
    To change the language that the Uconnect™ Phone is using: • Press the button to begin. • After the “Ready” prompt and the following beep, say the name of the language you wish to swit ...

    Supplemental Active Head Restraints (AHR) — If Equipped
    These head restraints are passive, deployable components, and vehicles with this equipment cannot be readily identified by any markings, only through visual inspection of the head restraint. The ...

    Front Heated Seats
    There are two heated seat switches that allow the driver and passenger to operate the seats independently. The controls for each heater are located on the switch bank below the climate controls. ...