Using The Remote Control

1. Press the MODE button on the Remote Control.

2. While looking at Screen 1 or 2, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER.

Select DISC Mode On The VES Screen
Select DISC Mode On The VES Screen

NOTE:
• Channel/Screen 1 select mode information is shown on the left side of the screen.
• Channel/Screen 2 select mode information is shown on the right side of the screen.
• The VES™ will retain the last setting when turned off.

    See also:

    Add Names To Your Uconnect™ Phonebook
    NOTE: Adding names to the Uconnect™ Phonebook is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say †...

    HSA Activation Criteria
    The following criteria must be met in order for HSA to activate: • Vehicle must be stopped. • Vehicle must be on a 6% (approximate) grade or greater hill. • Gear selection matches vehicle ...

    Jacking Instructions
    WARNING! Carefully follow these tire changing warnings to help prevent personal injury or damage to your vehicle: • Always park on a firm, level surface as far from the edge of the roadway a ...