Deploying The Crossbars
To deploy the crossbars, completely loosen the thumb screws at both ends of the crossbar and lift the crossbar from its stowed position in the side rail. Repeat with crossbar on the opposite side.
Loosening Crossbars
CAUTION!
Use care when removing and handling the crossbars
to prevent damage to the vehicle.
Bend the crossbar supports at each end, taking care to keep hand clear of pivoting joint. Slide the thumb screw down.
Stowed Position
Deployed Position
Then, position the crossbars across the roof.
NOTE:
The crossbars are identical and can be placed in
any two of the three deploy positions.
Deploy Positions – Choose Two Of Three
Make sure the directional arrows on the crossbars align with the directional arrows on the side rails. Set the crossbars into the deployed positions.
Crossbar To Side Rail Installation
Once the crossbars are set into position, tighten the thumb screws completely.
Tightening Crossbar
See also:
Headlights On With Wipers (Available With Automatic Headlights Only)
When this feature is active, the headlights will turn on
approximately 10 seconds after the wipers are turned on
if the headlight switch is placed in the AUTO position. In
addition, the headligh ...
Introduction
Congratulations on selecting your new Chrysler Group
LLC vehicle. Be assured that it represents precision
workmanship, distinctive styling, and high quality - all
essentials that are traditional ...
Enhanced Seat Belt Use Reminder System (BeltAlert )
BeltAlert is a feature intended to remind the driver and
front passenger (if equipped with front passenger
BeltAlert ) to fasten their seat belts. The feature is active
whenever the ignition is ...