To Activate


 

1. Select “Automatic High Beams — ON” through the EVIC. Refer to “Electronic Vehicle Information Center (EVIC)/Customer-Programmable Features” in “Understanding Your Instrument Panel” for further information.

2. Rotate the headlight switch counterclockwise to the AUTO (A) position.

3. Push the multifunction lever away from you to switch the headlights to the high beam position. Refer to “Multifunction Lever” in this section for further information.

NOTE:
This system will not activate until the vehicle is at, or above, 25 mph (40 km/h).

    See also:

    Jump-Starting Procedure
    If your vehicle has a discharged battery it can be jumpstarted using a set of jumper cables and a battery in another vehicle or by using a portable battery booster pack. Jump-starting can be dan ...

    SMS
    Uconnect™ Phone can read or send new messages on your phone. Your phone must support SMS over Bluetooth in order to use this feature. If the Uconnect™ Phone determines your phone is not com ...

    Rear Blower Control
    The primary control for the rear blower is on the front climate control unit, located on the instrument panel. Only when the front control for the rear blower is in the REAR position do the secon ...