To Exit Remote Start Mode And Drive The Vehicle


 

Before the end of the 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then insert the key into the ignition switch and turn the switch to the ON/RUN position.

NOTE:
The ignition switch must be in the ON/RUN position in order to drive the vehicle.

    See also:

    Heated Seats — If Equipped
    There are two heated seat switches that allow the driver and passenger to operate the seats independently. The controls for each heater are located on the center of the instrument panel (above t ...

    Manual Park Release — 8 Speed Transmission (3.6L Engine)
    WARNING! Always secure your vehicle by fully applying the parking brake, before activating the Manual Park Release. Activating the Manual Park Release will allow your vehicle to roll away if it ...

    Jump-Starting Procedure
    WARNING! Failure to follow this procedure could result in personal injury or property damage due to battery explosion. CAUTION! Failure to follow these procedures could result in damage to the ...