To Arm The System
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information).
• For vehicles equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF .
• For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF and the key is physically removed from the ignition.
2. Perform one of the following methods to lock the vehicle:
• Press LOCK on the interior power door lock switch with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to Keyless Enter-N-Go in Things To Know Before Starting Your Vehicle for further information).
• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If any doors are open, close them.
See also:
SERVICE TPM SYSTEM Message
The “Tire Pressure Monitoring Telltale Light” will flash
on and off for 75 seconds, and remain on solid when a
system fault is detected. The system fault will also sound
a chime. The EVIC wi ...
Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the button until you hear a
single beep,
indicating that the active and hold status of the two calls
have switched. Only one c ...
Controlling The iPod Or External USB Device Using Radio Buttons
To get into the iPod /USB/MP3 control mode and access
a connected audio device, either press the “AUX” button
on the radio faceplate or press the VR button and say
USB or Switch to USB . Onc ...