To Enter Remote Start Mode
Press and release the REMOTE START button on the RKE transmitter twice within five seconds.
The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.
NOTE:
• If an engine fault is present the vehicle will start and
then shut down 10 seconds later.
28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • For security, power window operation is disabled when the vehicle is in the Remote Start mode.
• The engine can be started two consecutive times (two 15 minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.
Remote start will also cancel if any of the following occur:
• The engine stalls or RPM exceeds 2500
• Any engine warning lamps come on
• Low Fuel Light turns on
• The hood is opened
• The hazard switch is pressed
• The transmission is moved out of PARK
• The brake pedal is pressed
See also:
Ride & Handling
The previous Town & Country's ride quality brought to mind a big American car
from the '70s; it rode softly, with a bit of wallowing thrown in. The 2011's new
suspension tuning keeps body moti ...
Power Mirrors
The power mirror controls are located on the driver’s
door trim panel.
Power Mirror Switch
To adjust a mirror, turn the control wand toward the left
or right mirror positions indicated. Tilt ...
Customer Key Programming
Programming Key Fobs or RKE transmitters may be
performed at an authorized dealer. ...