Hazard Warning Flashers


 

The Hazard Warning flasher switch is located in the center of the instrument panel between the center air outlets.

Press the switch to turn on the Hazard Warning

Press the switch to turn on the Hazard Warning flashers. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.

NOTE:
With extended use the Hazard Warning flashers may wear down your battery.

    See also:

    Front Park/Turn Signal Lamp
    1. Raise the hood to access the rear of the headlamp housing. 2. Twist the turn signal socket and remove from the headlamp housing, then pull the bulb out. 3. Push the new bulb into the socket a ...

    Pair (Link) Uconnect™ Phone To A Mobile Phone
    To begin using your Uconnect™ Phone, you must pair your compatible Bluetooth enabled mobile phone. To complete the pairing process, you will need to reference your mobile phone Owner’s Manual ...

    Closing Sunroof — Manual Mode
    To close the sunroof, press and hold the switch in the forward position. Any release of the switch will stop the movement and the sunroof will remain in a partially closed condition until the sw ...