Security
It is advised to erase all channels before you sell or turn in your vehicle.
To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased.
The HomeLink Universal Transceiver is disabled when the Vehicle Security Alarm is active.
See also:
In Canada
If you believe that your vehicle has a safety defect, you
should contact the Customer Service Department immediately.
Canadian customers who wish to report a safety
defect to the Canadian governm ...
Reset
• press the button.
• After the “Ready” prompt, and the following beep, say
“Setup”, then “Reset”.
This will delete all phone pairing, phone book entries,
and other settings in ...
Blind Spot Monitoring — If Equipped
The Blind Spot Monitoring (BSM) system uses two radarbased
sensors, located inside the rear bumper fascia, to
detect highway licensable vehicles (automobiles, trucks,
motorcycles, etc.) that ent ...