To Resume Speed
Press the RES + button and release. Then remove your foot from the accelerator pedal. The EVIC will display the last set speed.
NOTE:
You can resume ACC from a minimum of
20 mph (32 km/h).
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
See also:
Electrical Power Outlets — If Equipped
Two 12 Volt (13 Amp) power outlets are located on the
lower instrument panel, below the open storage bin. The
driver-side power outlet is controlled by the ignition
switch and the passenger-side ...
Manual Front Seat Adjustment
The manual seat adjustment bar is at the front of the seat,
near the floor.
Manual Seat Adjusting Bar
Pull the bar upward to move the seat forward or rearward.
Release the bar once the seat is ...
Disc Formats
The VES™ DVD player is capable of playing the following
types of discs (12 mm or 8 mm diameter):
• DVD-Video discs (MPEG-2 video compression) (see notes about DVD Region
Codes)
• DVD-Audio ...
