To Set A Desired Speed


 

Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected speed.

NOTE:
The vehicle should be traveling at a steady speed and on level ground before pressing the SET button.

    See also:

    Lane Change Assist
    Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. ...

    Rear Temperature Control
    To change the temperature in the rear of the vehicle, rotate the temperature knob counterclockwise to lower the temperature, and clockwise to increase the temperature. The rear temperature settin ...

    Fog Lights — If Equipped
    The front fog light switch is built into the headlight switch. Fog Light Switch To activate the front fog lights, turn on the parking lights or the low beam headlights and press the headli ...