Power Lumbar — If Equipped


 

Vehicles equipped with power driver or passenger seats may be also be equipped with power lumbar. The power lumbar switch is located on the outboard side of the power seat. Push the switch forward or rearward to increase or decrease the lumbar support. Push the switch upward or downward to raise or lower the lumbar support.

Power Lumbar Switch
Power Lumbar Switch

    See also:

    Operating Instructions — Radio Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. ...

    Programming A Non-Rolling Code
    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...

    Spare Tire Matching Original Equipped Tire And Wheel – If Equipped
    Your vehicle may be equivalent with a spare tire and wheel in look and function as the original equipment tire and wheel found on the front or rear axle of your vehicle. This spare tire may be us ...