General Information


 

This device complies with Part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following conditions:

• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause undesired operation.

    See also:

    Using The ENGINE START/STOP Button
    NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. To start the engine, the transmission must be in PARK or NEUTRAL. Press a ...

    Voice Command
    • For best performance, adjust the rearview mirror to provide at least 1⁄2 in (1 cm) gap between the overhead console (if equipped) and the mirror. • Always wait for the beep before spe ...

    To Arm The System
    Follow these steps to arm the Vehicle Security Alarm: 1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information). • For vehicle ...