To Arm The System
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information).
• For vehicles equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF.
• For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF and the key is physically removed from the ignition.
2. Perform one of the following methods to lock the vehicle:
• Press LOCK on the interior power door lock switch with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to Keyless Enter-N-Go in Things To Know Before Starting Your Vehicle for further information).
• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If any doors are open, close them.
See also:
Supplemental Seat-Mounted Side Air Bags (SAB)
Supplemental Seat-Mounted Side Air Bags (SAB) may
provide enhanced protection to help protect an occupant
during a side impact. The SAB is marked with an air bag
label sewn into the outboard sid ...
3.6L Engine
This engine is designed to meet all emissions
regulations and provide excellent
fuel economy and performance when using
high-quality unleaded “regular” gasoline
having an octane rating ...
Vehicles Equipped With Keyless Enter-N-Go
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the ON/
RUN position (Do not start the engine.)
2. Fully depress the accelerator pedal, slowly, t ...