Replacement Keys

NOTE:
Only Key Fobs that are programmed to the vehicle electronics can be used to start and operate the vehicle. Once a Key Fob is programmed to a vehicle, it cannot be programmed to any other vehicle.

CAUTION!
Always remove the keys from the vehicle and lock all doors when leaving the vehicle unattended.

At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN).

Keep the PIN in a secure location. This number is required for authorized dealer replacement of Key Fobs.

Duplication of Key Fobs may be performed at an authorized dealer, this procedure consists of programming a blank Key Fob to the vehicle electronics. Ablank Key Fob is one that has never been programmed.

NOTE:
When having the Sentry Key Immobilizer system serviced, bring all vehicle Key Fobs with you to an authorized dealer.

    See also:

    To Deactivate
    Perform either of the following steps to deactivate the SmartBeam™ system. 1. Select “Automatic High Beams — OFF” through the EVIC. Refer to “Electronic Vehicle Information Center (EV ...

    Rear Head Restraints
    The center head restraint has two positions, up or down. When the center seat is being occupied the head restraint should be in the raised position. When there are no occupants in the center seat ...

    Power Door Locks — If Equipped
    A power door lock switch is on each front door trim panel. Use this switch to lock or unlock the doors. Driver Power Door Lock Switches If you press the power door lock switch while the Key ...