Front Turn Signal

1. Raise and prop open the hood.

2. Rotate the bulb’s electrical connector one-quarter turn counterclockwise and remove it from the headlamp housing.

3. Remove the bulb from the connector socket and install the replacement bulb.

4. Install the bulb and connector assembly into the headlamp housing and rotate the connector one-quarter turn clockwise to lock it in place.

    See also:

    Base System
    The Tire Pressure Monitor System (TPMS) uses wireless technology with wheel rim mounted electronic sensors to monitor tire pressure levels. Sensors, mounted to each wheel as part of the valve st ...

    Safety, Features & Pricing
    Well over half the new 300's structure is made up of higher-strength steel than before, Chrysler says, and the results show. With top scores in front, side and rear impact crash tests, as well as ...

    Towing Requirements – Trailer Brakes
    • Do not interconnect the hydraulic brake system or vacuum system of your vehicle with that of the trailer. This could cause inadequate braking and possible personal injury. • An electronica ...