Seat Belt Maintenance :: Appearance Care And Protection From Corrosion :: Maintenance Procedures :: Maintaining your vehicle :: Chrysler 200 Owners Manual :: Chrysler 200 Convertible - Chryclub.com

Seat Belt Maintenance

Chrysler 200 Convertible / Chrysler 200 Owners Manual / Maintaining your vehicle / Maintenance Procedures / Appearance Care And Protection From Corrosion / Seat Belt Maintenance

Do not bleach, dye, or clean the belts with chemical solvents or abrasive cleaners. This will weaken the fabric.

Sun damage can also weaken the fabric.

If the belts need cleaning, use a mild soap solution or lukewarm water. Do not remove the belts from the car to wash them. Dry with a soft cloth.

Replace the belts if they appear frayed or worn or if the buckles do not work properly.

See also:

Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...

Gross Axle Weight Rating (GAWR)
The GAWR is the maximum capacity of the front and rear axles. Distribute the load over the front and rear axles evenly. Make sure that you do not exceed either front or rear GAWR. WARNING! Bec ...

Fog Lights — If Equipped
The front fog light switch is on the multifunction lever. To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out the end of the multifunction leve ...