Shift Lever Override


 

If a malfunction occurs and the shift lever cannot be moved out of the PARK position, you can use the following procedure to temporarily move the shift lever:

1. Firmly apply the parking brake.

2. Remove the cupholder liner.

3. Turn the ignition to the ON/RUN position without starting the engine.

4. Press and maintain firm pressure on the brake pedal.

5. Insert a screwdriver or similar tool into the hole at the front of the cupholder and push and hold the override lever forward.

6. Move the shift lever into the NEUTRAL position.

7. The vehicle may then be started in NEUTRAL.

8. Reinstall the cupholder liner.

    See also:

    Power Seats — If Equipped
    The power seat switches are on the outboard side of the seat near the floor. Use the bottom switch to move the seat up, down, forward, rearward, or to tilt the seat. The top switch controls the ...

    Display
    After pressing the Display soft-key the following settings will be available. • Display Mode When in this display you may select one of the auto display settings. To change Mode status, touch ...

    Master Cylinder – Brake Fluid Level Check
    Check the fluid level in the master cylinder immediately if the brake system warning light indicates system failure. Check the fluid level in the master cylinder when performing underhood service ...