Six-Speed Automatic Transmission (62Te) — If Equipped

Chrysler 200 Convertible / Chrysler 200 Owners Manual / Starting and operating / Automatic Transmission / Six-Speed Automatic Transmission (62Te) — If Equipped

 

The shift lever position display (located in the instrument panel cluster) indicates the transmission gear range. You must press the brake pedal to move the shift lever out of the PARK position (refer to “Brake/Transmission Shift Interlock System” in this section). To drive, move the shift lever from PARK or NEUTRAL to the DRIVE position.

The electronically-controlled transmission provides a precise shift schedule. The transmission electronics are self-calibrating; therefore, the first few shifts on a new vehicle may be somewhat abrupt. This is a normal condition, and precision shifts will develop within a few hundred miles (kilometers).

Shifting from DRIVE to PARK or REVERSE should be done only after the accelerator pedal is released and the vehicle is stopped. Be sure to keep your foot on the brake pedal when moving the shift lever between these gears.

The transmission shift lever has PARK, REVERSE, NEUTRAL, DRIVE, and AutoStick shift positions. Manual shifts can be made using the AutoStick shift control (refer to “AutoStick ” in “Starting And Operating” for further information). Moving the shift lever to the left or right (-/+) while in the AutoStick position (below the Drive position) will manually select the transmission gear, and will display the current gear in the instrument cluster as 6, 5, 4, 3, 2, 1.

Shift Lever
Shift Lever

    See also:

    To Arm The System
    Follow these steps to arm the Vehicle Security Alarm: 1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information). • For vehicle ...

    Driver Memory Seat — If Equipped
    The Memory Buttons 1 and 2 on the driver’s door panel can be programmed to recall the driver’s seat, driver’s outside mirror, adjustable brake and accelerator pedals, and radio station pre ...

    Operation
    Voice commands can be used to operate the Uconnect™ Phone and to navigate through the Uconnect™ Phone menu structure. Voice commands are required after most Uconnect™ Phone prompts. You wi ...