Automatic Transmission


 

CAUTION!
Damage to the transmission may occur if the following precautions are not observed:

• Shift into PARK only after the vehicle has come to a complete stop.

• Shift into or out of REVERSE only after the vehicle has come to a complete stop and the engine is at idle speed.

• Do not shift between PARK, REVERSE, NEUTRAL, or DRIVE when the engine is above idle speed.

• Before shifting into any gear, make sure your foot is firmly pressing on the brake pedal.

NOTE:
You MUST press and hold the brake pedal while shifting out of PARK.

WARNING!
• It is dangerous to move the shift lever out of PARK or NEUTRAL if the engine speed is higher than idle speed. If your foot is not firmly pressing on the brake pedal, the vehicle could accelerate quickly forward or in reverse. You could lose control of the vehicle and hit someone or something.

Only shift into gear when the engine is idling normally and when your foot is firmly pressing on the brake pedal.

• Unintended movement of a vehicle could injure those in and near the vehicle. As with all vehicles, you should never exit a vehicle while the engine is running. Before exiting a vehicle, always apply the parking brake, shift the transmission into PARK, and remove the ignition key. Once the key is removed, the shift lever is locked in the PARK position, securing the vehicle against unwanted movement. Furthermore, you should never leave children unattended inside a vehicle.

See also:

Onboard Diagnostic System — OBD II
Your vehicle is equipped with a sophisticated onboard diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and automatic transmission control systems. ...

Fuel Economy
Press and release the UP or DOWN button until Fuel Economy is highlighted. Press the SELECT button and the next screen will display the following: • Average Fuel Economy/Miles Per Gallon • D ...

Removal
The Quad seats can be removed if additional storage is needed. With the seat in the easy entry position, lift the cross beam forward and up to release the front anchor latches. Cross Beam for ...