General Information


 

This device complies with FCC rules Part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference that may be received including interference that may cause undesired operation.

NOTE:
• The transmitter has been tested and it complies with FCC and IC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.

• The term IC before the certification/registration number only signifies that Industry Canada technical specifications were met.

    See also:

    Third Row Power Folding Seat — If Equipped
    A one-touch power folding seat switch is located in the left rear trim panel as part of a switch bank. NOTE: Lower the head restraint by pulling on the release strap marked “1” located on th ...

    Ignition Off Operation
    For vehicles not equipped with the Electronic Vehicle Information Center (EVIC), the power sunroof switch will remain active for 45 seconds after the ignition switch is turned OFF. Opening eithe ...

    Preparations For Jump-Start
    The battery in your vehicle is located between the left front headlight assembly and the left front wheel splash shield. To allow jump-starting there are remote battery posts located on the left ...