Voice Command

• For best performance, adjust the rearview mirror to provide at least 1⁄2 in (1 cm) gap between the overhead console (if equipped) and the mirror.

• Always wait for the beep before speaking.

• Speak normally, without pausing, just as you would speak to a person sitting a few feet/meters away from you.

• Make sure that no one other than you is speaking during a Voice Command period.

• Performance is maximized under:
• low-to-medium blower setting,
• low-to-medium vehicle speed,
• low road noise,
• smooth road surface,
• fully closed windows,
• dry weather condition.

• Even though the system is designed for users speaking in North American English, French, and Spanish accents, the system may not always work for some.

• When navigating through an automated system such as voice mail, or when sending a page, at the end of speaking the digit string, make sure to say “Send”.

• Storing names in the phonebook when the vehicle is not in motion is recommended.

• It is not recommended to store similar sounding names in the Uconnect™ Phonebook.

• Phonebook (Downloaded and Uconnect™ Phone Local) name recognition rate is optimized when the entries are not similar.

• Numbers must be spoken in single digits. “800” must be spoken “eight-zero-zero” not “eight hundred”.

• You can say “O” (letter “O”) for “0” (zero).

• Even though international dialing for most number combinations is supported, some shortcut dialing number combinations may not be supported.

• In a convertible vehicle, system performance may be compromised with the convertible top down.

    See also:

    Gross Axle Weight Rating (GAWR)
    The GAWR is the maximum capacity of the front and rear axles. Distribute the load over the front and rear axles evenly. Make sure that you do not exceed either front or rear GAWR. WARNING! Bec ...

    Closing Sunroof — Express
    Press the switch forward and release it within one-half second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically. This is called “E ...

    Remote Lock Doors And Liftgate
    Press and release the LOCK button on the RKE transmitter to lock all doors and liftgate. The turn signal lights will flash and the horn will chirp to acknowledge the signal. ...