Turning Confirmation Prompts ON/OFF

Turning confirmation prompts off will stop the system from confirming your choices (e.g., the Uconnect™ Phone will not repeat a phone number before you dial it).
• Press the button to begin.
• After the “Ready” prompt and the following beep, say one of the following:
− “Setup Confirmation Prompts On”
− “Setup Confirmation Prompts Off”

    See also:

    Overloading
    The load carrying components (axle, springs, tires, wheels, etc.) of your vehicle will provide satisfactory service as long as you do not exceed the GVWR and front and rear GAWR. The best way t ...

    To Arm The System
    Follow these steps to arm the Vehicle Security Alarm: 1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information). • For vehicle ...

    Programming A Non-Rolling Code
    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...