Call Termination

To end a call in progress, momentarily press the button. Only the active call(s) will be terminated and if button. Only the active call(s) will be terminated and if there is a call on hold, it will become the new active call.

If the active call is terminated by the phone far end, a call on hold may not become active automatically. This is cell phone-dependent. To bring the call back from hold, press and hold the a single beep. button until you hear a single beep.

    See also:

    General Information
    This device complies with FCC rules Part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device m ...

    Rear Temperature Control
    The rear mode selection REAR, allows the settings to be controlled by the rear mode control knob. To change the temperature in the rear of the vehicle, rotate the temperature control knob counter ...

    Electronic Speed Control — If Equipped
    When engaged, the Electronic Speed Control takes over accelerator operations at speeds greater than 25 mph (40 km/h). The Electronic Speed Control buttons are located on the right side of the s ...