Call By Saying A Name

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Call”.

• The system will prompt you to say the name of the person you want to call.

• After the “Ready” prompt and the following beep, say the name of the person you want to call. For example, you can say “John Doe”, where John Doe is a previously stored name entry in the Uconnect™ phonebook or downloaded phonebook. To learn how to store a name in the phonebook, refer to “Add Names to Your Uconnect™ Phonebook”, in the phonebook.

• The Uconnect™ system will confirm the name and then dial the corresponding phone number, which may appear in the display of certain radios.

    See also:

    INFO Button
    Pressing the INFO button will cycle the display information between Artist, Song Title, and Composer (if available). Also, pressing and holding the INFO button for an additional three seconds wil ...

    Turning Parkview On Or Off — Without Navigation/Multimedia Radio
    1. Press the “menu” hard-key. 2. Select “system setup” soft-key. 3. Enable or disable the rear camera feature by selecting “enable rear camera in reverse” soft-key. ...

    Trailer And Tongue Weight
    Always load a trailer with 60% to 65% of the weight in the front of the trailer. This places 10% to 15% of the Gross Trailer Weight (GTW) on the tow hitch of your vehicle. Loads balanced over th ...