Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a “gASCAP” message will display in the odometer or a “CHECK GASCAP” message will be displayed in the Electronic Vehicle Information Center (EVIC). Refer to “Electronic Vehicle Information Center (EVIC)” in ”Understanding Your Instrument Panel” for further information.
Tighten the gas cap until a clicking sound is heard.
This is an indication that the gas cap is properly tightened.
Press the odometer reset button to turn the message off.
If the problem persists, the message will appear the next time the vehicle is started. This might indicate a damaged cap. If the problem is detected twice in a row, the system will turn on the MIL. Resolving the problem will turn the MIL light off.
See also:
Transmission Limp Home Mode
Transmission function is monitored electronically for
abnormal conditions. If a condition is detected that could
result in transmission damage, Transmission Limp Home
Mode is activated. In this ...
Instrument Cluster Descriptions
1. Temperature Gauge
The temperature gauge shows engine coolant temperature.
Any reading below the red mark of the gauge shows
that the engine cooling system is operating properly. The
gauge poi ...
Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) —
If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prematurely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Aja ...