Using The Remote Control

1. Press the MODE button on the Remote Control.

2. While looking at Screen 1 or 2, highlight VES DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER on the Remote Control.

Select VES DISC Mode On The VES Screen
Select VES DISC Mode On The VES Screen

NOTE:
• Channel/Screen 1 select mode information is shown on the left side of the screen.
• Channel/Screen 2 select mode information is shown on the right side of the screen.
• The VES™ will retain the last setting when turned off.

    See also:

    Messages #
    Select from Main Menu using the UP or DOWN buttons. This feature shows the number of stored warning messages (in the # place holder). Pressing the SELECT button will allow you to see what the sto ...

    Controlling The Rear Climate Controls From The Front ATC Panel
    The Three-Zone ATC system allows for adjustment of the rear climate controls from the front ATC panel. To change the rear system settings: 1. Press REAR button to change control to rear control ...

    Department Of Transportation Uniform Tire Quality Grades
    The following tire grading categories were established by the National Highway Traffic Safety Administration. The specific grade rating assigned by the tire’s manufacturer in each category is ...