Operating Instructions — Radio Mode

NOTE:
The ignition switch must be in the ON/RUN or ACC position to operate the radio.

See also:

Programming A Non-Rolling Code
For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...

Electrical Power Outlets — If Equipped
Two 12 Volt (13 Amp) power outlets are located on the lower instrument panel, below the open storage bin. The driver-side power outlet is controlled by the ignition switch and the passenger-side ...

Spare Tire Removal
The spare tire is stowed inside a protective cover located under the center of the vehicle between the front doors by means of a cable winch mechanism. The “spare tire drive” nut is located ...